LX0APD is on air

During Summer I started experimenting with different setups for a APRS Digi. In September I found very good hardware components from DC4ZZ & DB3FAT. I installed the system beginning of September on VHF and UHF using a temporary antenna and the callsign LX1DUC-4. On December 9, 2014 I received my license for the callsign LX0APD. The callsign LX0APD-4 is now on air as an APRS iGate and fill-in digipeater on VHF (144,800 MHz) and UHF (432,500 MHz) using a extremely low TX power of 16dbm.

Basic paranoid iptables firewall for an AMPRnet gateway

I have been asked a couple of times to provide a starting point for a firewall based on iptables for AMPRnet gateways based on Linux. I’ll try to accomplish this here.

I’m assuming your Linux gateway uses the following interfaces:

  • eth0 : connected to the Internet, has a public static IP address (this post does NOT cover AMPRnet gateways behind NAT or within DMZ)
  • eth1 : connected to your local AMPRnet LAN, has a static 44net IP address
  • tunl0 : the IPIP tunnel interface

The following script will allow to receive IPIP, RIPv2 and Management traffic. It will also allow connection to be initiated from the gateway or the LAN by employing a stateful firewall:

Continue reading “Basic paranoid iptables firewall for an AMPRnet gateway”

HowTo setup an AMPRnet Gateway on Linux

I had to setup many AMPRnet gateways on Linux machines and I always had a hard time remembering the different steps, so I try to provide a quick start over here.

I have been using the RIP44d deamon for all my installations, so we’ll start with downloading the current version of RIP44d:

sudo wget -O /usr/local/sbin/rip44d https://raw.github.com/hessu/rip44d/master/rip44d

The file needs to be executable by root

sudo chmod 744 /usr/local/sbin/rip44d

Continue reading “HowTo setup an AMPRnet Gateway on Linux”