The Fritz!Box supports HD Voice with voipGATE.

It was time again to re-install my Fritz!Box, unfortunately the box does crash sometimes and only a factory reset brings the broken services back to life (in between those crashes the box actually runs very solid).

So I setup all of my local services and DECT phones and concluded with the setup of my VoIP accounts. While testing ingress calls I noticed a nice HD icon on my DECT phones’ display. The Fritz!Box GUI surely lists my test calls with Codec G.722.

FB-G722

I have tested HD Voice with voipGATE.

No public IP for EPT LuxFibre

EPT has officially launched the LuxFibre service beginning of September, although there are rumors that some friendly test customers had LuxFibre installation in service prior to September 2011.
Some LuxFibre users already reported that the standard LuxFibre service (no optional serviced booked) does not provide a public IP address on WAN interface. EPT assigns a private IP address by default, so the user’s Internet access will be subject to NAT44 (aka double IPv4 NAT). NAT44 breaks all kind of services mostly those which already have difficulties with single/simple NAT. EPT optionally assigns a dynamic and public IP address to the WAN interface of your router. This will allow Internet access with single/simple NAT, however at the cost of 1,99 EUR / month (http://www.pt.lu/portal/lang/en/telecom/pid/4061).
Some may say it’s time for IPv6, a service available from EPT free of charge as an OPT-IN service (http://www.pt.lu/portal/lang/en/telecom/pid/3998).

IPv6 route table limits under Linux

I have been experimenting with IPv6 addressing and routing under different Linux flavors. Addressing in LANs is quite easy with Auto/Zero-Conf, however for Auto/Zero-Conf you need to use /64 network, which could lead to memory exhaustion due to a Neighbor Discovery attack (I will write more on this later, so check below for related articles). Routing is equally simple to setup with Router Advertisements.

So I wanted to go a step further and loaded a full IPv6 routing table via BGP into a linux box. Mine unfortunately had a limit in the kernel, actually net.ipv6.route.max_size was set to 4096. The BGP feed I used delivered 6419 prefixes and only 4068 were loaded into the kernel table. Continue reading “IPv6 route table limits under Linux”

ILR opens range 28 for allocation

Luxembourg’s regulator has opened the numbering range 28 for allocation to operators on July 1, 2011. The range was long time blocked for historical reasons.

Prior to May 1, 2006 the mobile network operator LUXGSM used the numbering range 028 for its mobile voicemail service. Due to the common practice to omit the leading 0 when dialing a number from abroad, the numbering range 28 was aliased to 028 when called from abroad. This obviously rendered the numbering range 28 unusable for other services. Continue reading “ILR opens range 28 for allocation”

ILR releases public NP DB lookup

Luxembourg’s Regulator has published to web-based number-portability database look-up portals for the fixed and mobile networks.

http://www.ilr.public.lu/communications_electroniques/numerotation/portabilite_des_numeros/index.html

Or the direct links:

fixed numbers: http://lookuplux.systor.st/lux_lookup_001/lookup.html?lang=4&ism=0
mobile numbers: http://lookuplux.systor.st/lux_lookup_001/lookup.html?lang=4&ism=1