IPTV on Bamboo with a Mikrotik router

Getting to work an IPTV decoder on a POST Bamboo access with a Mikrotik router instead of Fritz!Box has been one of my long time challenges that I never got around. But finally I got it done, here is how to reproduce it.

I used ether1 port on the Mikrotik to connect to the GPON network termination unit (NTU). As POST uses VLAN 35 as the transport VLAN, i created a vlan interface on top of ether1.

The interface IPTV is a bridge as I distributed IPTV to a VLAN present on several interfaces.

Continue reading “IPTV on Bamboo with a Mikrotik router”

Using a RouterOS to connect to POST LuxFibre

I have used a Routerboard running Mikrotik’s RouterOS to connect to a POST LuxFibre FTTH access for some time. I have been asked in the past to aid with similar setups, so here comes my configuration for the RouterOS CLI.

Note: This setup does NOT (yet) provide access to the Voice service delivered by POST.

In this example I’m using “ether1” to connect to the GPON NTU. (I haven’t yet tested the RouterBoard GPON SFP module, so no need to ask about it 🙂 ) Continue reading “Using a RouterOS to connect to POST LuxFibre”